HESPER

Search this site

95–310 mm automatic hot-and-cold tape cutters

Webbing cut-to-length and edge sealing

See how the 95–310 mm automatic hot-and-cold tape cutters turn webbing rolls into cut lengths. Check the end finish for sewing, fitting hardware or packing.

Close-up of a heat-sealed webbing end
Example of a heat-sealed webbing end

Does the cut end need sealing?

Cold cut to length

Try a cold cut when ends need to stay soft, will be sewn over or should avoid heat. Check for fraying during sewing or when threading through hardware.

Hot cut to length and seal

Try hot-knife cutting and sealing on suitable nylon, polyester or other synthetic webbing. Confirm the fibre, weave and coating, then inspect the cooled ends for stiffness or beading.

Need holes, V-notches or an ultrasonic process? Explore other tape cutters

From webbing roll to cut pieces

  1. Unwind

    Check the width, thickness and number of rolls.

  2. Guide and feed

    Allow room for guides between lanes and check each strip feeds evenly.

  3. Cut to length

    Choose a cold or hot knife for the material and required cut end.

  4. Collect and inspect

    Let the pieces cool, then measure them and try them in the next operation.

Feed guides and touchscreen on the Model 320
Feed guides and touchscreen on the Model 320

Watch the cutters feed and cut

Model 320 parallel webbing cutting

The demonstration uses ten strips. Confirm your lane count from your strip widths, guide spacing, feeding and collection.

Watch on YouTube

Cutting different tape materials

Observe how webbing, hook-and-loop tape and zipper tape feed and cut. Use your own material samples to compare results.

Watch on YouTube

What to check in a cutting trial

  • LengthMeasure several consecutive pieces the same way. For parallel cutting, check every lane.
  • Cut endLook for fraying, joined threads or a hard bead. Inspect the ends after cooling.
  • Next operationTry the cut piece through the intended buckle, or sew, sort and pack it as you normally would.
  • Accepted outputRun your actual cut length and include collection and rejection checks when counting usable output.

Related guides